AudioCodes Media 800 MSBR

User's Manual 960 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
[SwapTel2IPCalled&Callin
gNumbers]
Determines whether the device swaps the calling and called numbers
received from the Tel side (for Tel-to-IP calls). The SIP INVITE
message contains the swapped numbers.
 [0] = (Default) Disabled
 [1] = Swap calling and called numbers
Note: This parameter can also be configured in a Tel Profile.
Web/EMS: Add Prefix to
Redirect Number
CLI: add-pref-to-redir-nb
[Prefix2RedirectNumber]
Defines a string prefix that is added to the Redirect number received
from the Tel side. This prefix is added to the Redirect Number in the SIP
Diversion header.
The valid range is an 8-character string. The default is an empty string.
Web: Add Number Plan and
Type to RPI Header
EMS: Add Ton 2 RPI
CLI: np-n-type-to-rpi-hdr
[AddTON2RPI]
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.
 [0] No
 [1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1) and
AddTON2RPI = 1, it's possible to configure the calling and called
number type and number plan using the Number Manipulation tables for
Tel-to-IP calls.
Web/EMS: Source
Manipulation Mode
CLI: src-manipulation
[SourceManipulationMode
]
Determines the SIP headers containing the source number after
manipulation:
 [0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.
 [1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
source number before manipulation.
Calling Name Manipulations IP-to-Tel Table
CLI: configure voip > gw
manipulations calling-name-
map-ip2tel
[CallingNameMapIp2Tel]
Configures rules for manipulating the calling name (caller ID) in the
received SIP message for IP-to-Tel calls. This can include modifying or
removing the calling name. The format of this table ini file parameter is
as follows:
[ CallingNameMapIp2Tel ]
FORMAT CallingNameMapIp2Tel_Index =
CallingNameMapIp2Tel_DestinationPrefix,
CallingNameMapIp2Tel_SourcePrefix,
CallingNameMapIp2Tel_CallingNamePrefix,
CallingNameMapIp2Tel_SourceAddress,
CallingNameMapIp2Tel_RemoveFromLeft,
CallingNameMapIp2Tel_RemoveFromRight,
CallingNameMapIp2Tel_LeaveFromRight,
CallingNameMapIp2Tel_Prefix2Add,
CallingNameMapIp2Tel_Suffix2Add;
[ \CallingNameMapIp2Tel ]
Note: For a detailed description of this table, see 'Configuring SIP
Calling Name Manipulation' on page 310.
Calling Name Manipulations Tel-to-IP Table
CLI: configure voip > gw
manipulations calling-name-
map-tel2ip
[CallingNameMapTel2Ip]
This table parameter configures rules for manipulating the calling name
(caller ID) for Tel-to-IP calls. This can include modifying or removing the
calling name.
[ CallingNameMapTel2Ip ]
FORMAT CallingNameMapTel2Ip_Index =