• Clear GVRP state machine using clear gvrp state-machine [port-name]
command.
•
• Enable GVRP debug traces using the debug gvrp <all | packet | event |
timer> command. This will allow you to trace packets, events, and verify timers. Use
the no for of this command to disable debugging.
Troubleshooting IGMP Snooping
This section details techniques used to troubleshoot IGMP Snooping.
Troubleshooting a configuration failure
VLAN not present
Error: Invalid vlan-id (3)
For
IGMP Snooping to be enabled on a VLAN, the VLAN has to be present during configuration.
Refer user guide on how to create a VLAN.
Mrouter port configuration failure
Error: Interface (ethernet1/1) not found
For configuring a mrouter port, the port needs to be present as a bridge port before
configuration. Refer user guide on how to create a bridge port.
Troubleshooting a Data Link Layer problem
102 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
