Avaya 2330/4134 - Removing an Unresponsive Session; Defining Default Boot Parameters; Upgrading the Normal and Golden Bootroms

Procedure steps
To clear an inactive session, issue the following command:
clear telnet_session <1-16>
To view active telnet sessions, use the command show users. Using this command
will display which session (or user) owns Configuration Mode (conf term).
Removing an unresponsive session
This procedure describes the steps to remove an unresponsive session.
Procedure steps
To remove an unresponsive session, due to a "hung" router, issue the following
command:
debug clear_clisession <1-16>
To
view active telnet sessions, use the command show users. Using this command
will display which session (or user) owns Configuration Mode (conf term).
Defining default boot parameters
This procedure describes the steps necessary to define default boot parameters.
Procedure steps
1. Enter Configuration Mode.
configure terminal
2. Define boot parameters.
boot_params
To see an example of defining boot parameters, see Booting from a network FTP server on
page 41
or
Booting from USB on page 43
Upgrading the normal and golden bootroms
Use
the procedures in this section to upgrade the normal and golden bootroms on the Secure
Router 2330/4134.
Global troubleshooting tasks
22 Troubleshooting August 2013
Comments? infodev@avaya.com