Avaya 2330/4134 - Debug Cas; Debug Ccsip All

• debug ccsip errors on page
305
•
debug ccsip media on page 305
• debug ccsip messages on page 306
• debug isdn q921 on page 306
• debug isdn q931 on page 307
• debug pots on page 307
• debug voice cc on page 307
• debug voip dial-peer on page 308
debug cas
Use this command to enable CAS related debugging. Use the no form of this command to
disable the debug messages.
Syntax
[no] debug cas [slot <slot[/subslot/]port>] debug_identifier <debug-
level>
Table 70: Variable definitions
Variable Value
<slot/[<subslot/]port> Specifies the port number of the voice card.
<debug-level> Specifies the debug level: all, signal, or
callcontrol.
Example
SR# debug cas slot 1/1
debug ccsip all
Use this command to enable SIP related call control debugging. Use the no form of this
command to disable the debug messages.
Syntax
[no] debug ccsip all
Example
SR# debug ccsip all
Troubleshooting a SIP Media Gateway problem
304 Troubleshooting August 2013
Comments? infodev@avaya.com