Command fails with Maximum # of member ports reached for Channel-Group
error
Verify the number of lines in the LAG does not exceed the maximum. Use the show lacp
member-port and show lacp channel-group
commands.
Troubleshooting a operational failure
First verify created channel groups (lag) using the show bridge port command.
LAG interface is down
•
You should have verified the port states prior to adding them in the channel group. Use
show interface <interface> command to verify the port state.
• In the case the interface is in down state, check other end of the connection.
•
In the case all the ports are configured correctly and are in UP states, verify that LACP
configuration on both sides. Use show lacp member-port and show lacp
channel-group commands. Verify at least one end of each interface is configured as
Active.
Troubleshooting Link Aggregation
Troubleshooting August 2013
97
To Next Page
Loading...
