• Enable
console logging and also change the event-log priority to info. See
Configuring
the system for console logging on page 381
.
• Enable system logging and also change the sys-log priority to info. See
Configuring
the system for syslog reporting on page 376
.
Syntax
threshold total red <%red> green <%green> interval <interval> notify
<type>
Table 78: Variable definitions
Variable Value
<%red> Red threshold in percentage. (Default: 85)
<%green> Green threshold in percentage. (Default: 70)
<interval> Duration in seconds for which the CPU
utilization is measured. You can enter
multiples of 10 up to a maximum of 300
seconds. (Default: 30)
<type>
• cont - this type generates notification
periodically at the interval specified.
• once
- this type generates notification once
when the utilization changes from one
threshold to another threshold.
(Default: once)
Example
•
SR/configure/process cpu# threshold total red 90 green 50
interval 10 notify cont
•
SR/configure/process cpu# threshold total red 90 green 50
interval 10 notify once
CPU utilization debug commands
This section provides the CPU utilization debug commands.
Related topics:
debug process start-history on page 371
debug process stop-history on page 371
Troubleshooting high CPU utilization
370 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
