LED Description
• Off: No power available to the module
•
Yellow: Out of service, or failed to initiate
• Green: Power on and the module is operational.
LINK/STAT Status of each interface:
• Off: Not connected or the interface is out of service.
• Yellow: The interface is in a loopback mode or is running
diagnostics
• Green: The link or channel is active and receiving a valid signal
To view DS3 alarms, run the following command:
show module alarms ds3
Troubleshooting CT3
This section describes steps you use to troubleshoot CT3.
The following table describes the LED states for the CT3 Medium Module.
Table 21: CT3 Module LEDs
LED Description
STAT General module status:
•
Off: No power available to the module
• Yellow: Out of service, or failed to initiate
• Green: Power on and the module is operational.
LINK/STAT Status of each interface:
• Off: Not connected or the interface is out of service.
• Yellow: The interface is in a loopback mode or is running
diagnostics
• Green: The link or channel is active and receiving a valid signal
To view CT3 alarms, run the following command:
show module alarms ct3
Troubleshooting CT3
Troubleshooting August 2013 63
To Next Page
Loading...
