Troubleshooting Static LSP
This section details the steps and commands used to troubleshoot Static LSPs.
For static LSP, since there is no signaling most problems might be due to the configuration
and forwarding plane. Follow the below steps to troubleshoot the problem.
Procedure steps
1.
Ensure all MPLS prerequisites are satisfied.
2. Ensure the static FTN and static ILM are configured properly with valid interface
and labels: show mpls static-ftn show mpls static-ilm
3. Check the forwarding table entry for CLI-FTN: show mpls table-forwarding
4. Check the routing table for MPLS static routes: show ip route
5. Make sure the particular MPLS route is selected: show ip route database
Troubleshooting an MPLS problem
112 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
