Avaya 2330/4134 - Unable to Make Calls on T1 CAS

Figure 66: debug isdn q931 sample output (continued)
Unable to make calls on T1 CAS
If you cannot make calls on a T1 CAS port, see the following sections for troubleshooting
instructions.
Verify the T1 CAS configuration
If you cannot make calls on a T1 CAS port, make sure the T1 CAS configuration is correct.
The following is a typical configuration:
config term
module t1 1/2
cas-group timeslots 1-24 em-wink-start
exit
voice-port 1/2
no shutdown
exit
Be sure to enter no shutdown under voice-port. (Note that ISDN ports are enabled by
default.)
Troubleshooting a SIP Media Gateway problem
330 Troubleshooting August 2013
Comments? infodev@avaya.com