Avaya 2330/4134 - Showing BERT Test Results and Status

test <module> <identifier>
Example:test t1 6/3
2.
Issue the command to begin BERT testing, accompanied by the pattern type and
duration.
bert <patterntype> <interval>
Table 12: Variable definition
Variable Value
<identifier> The module identifier.
<interval> The duration of the test, in minutes. If not otherwise specified,
the default setting will be continuous.
<module> The module type. Applicable modules are T1, E1, T3, and
CT3. Only modules that are present will be available for
testing.
<patterntype> The BERT test pattern type. Possible choices are:
• 2^11 - 2^11 pattern
• 2^15 - 2^15 pattern
• 2^20 - 2^20 pattern
• QRSS
- QRSS pattern (default)
Showing BERT test results and status
To display BERT testing results and status, perform the following steps:
Procedure steps
1.
Issue the test command, accompanied by the module type and identifier.
test <module> <identifier>
Example:test t1 6/3
2. Issue the command to display test results and status. Note that this command can
also be issued from the CLI root.
show module test <module> <identifier>
Table 13: Variable definition
Variable Value
<identifier> The module identifier.
BERT
Troubleshooting August 2013 47