Chapter 8: Troubleshooting Ethernet CFM
Use the commands in this section to troubleshoot Ethernet Connectivity Fault Management (CFM). To
configure Ethernet CFM, see Avaya Secure Router 2330/4134 Configuration — Layer 2 Ethernet
(NN47263-501).
Ethernet CFM debug commands
This section provides the Ethernet CFM debug commands.
debug oam cfm dump-data
Use this command to enable or disable the dump of data for Ethernet CFM.
Syntax
cfm dump-data {0|1}
Table 44: Variable definitions
Variable Value
{0 | 1} Enables or disables the "dump" of data.
Enter 0 to disable and 1 to enable. The
default value is 0.
Example
SR/debug/oam# cfm dump-data 0
debug oam cfm debug-feature debug-level
Use this command to specify the feature to debug and the level at which to debug.
The Avaya Secure Router 2330/4134 does not write the debug information to a log file. The
Secure Router 2330/4134 displays the debug information only on your screen.
Important:
You
can use a debug level of 1 to 4. As the level increases, the amount of debug information
also increases.
Troubleshooting August 2013 107
To Next Page
Loading...
