Important:
Use the debug commands with caution. The debug command output is code-specific. Use
the show commands to understand the behavior of your system.
Syntax
cfm debug-feature <"value"> debug-level <level>
Table 45: Variable definitions
Variable Value
<level> Sets the debug level. Enter a value in the
range of 0 to 4. The default value is 0. The
level values correspond to the following
descriptions:
•
0 = none
• 1 = major
• 2 = minor
• 3 = detail
• 4 = flood
<"value"> Specifies the feature. Use quotation marks
around the feature description. The feature
description can be up to 127 characters and
uses any of the following words:
•
ALL
• CCI
• CCR
• CLI
• DISPATCH
• ERR
• FRAME
• LB
• LPORT
• LT
• MA
• MD
• MEP
• MIP
• PORT
Troubleshooting Ethernet CFM
108 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
