Configuring the Syslog source address
Use the following procedure to configure the Syslog server source address for all services.
Procedure Steps
1.
To configure source addresses for a service, enter Configuration Mode.
configuration terminal
2. Enter the system logging subtree.
system logging
3. Enter the syslog subtree.
syslog
4. Configure the source address.
source-address <[ip-address]|[interface-name]>
Table 88: Variable definitions
Variable Value
[ip-address] Specifies the source address by IP address.
[interface-name] Specifies the source address by interface name.
Configuring the system for console logging
Use the commands in this section to enable console logging and to define parameters for
console messages.
Procedure steps
1. To access configuration mode, enter:
configure terminal
2. To enable or disable console logging, enter:
system logging console {enable|disable}
3. To specify the messages to log to the console based on severity level, enter:
system logging console priority <priority>
Configuring the system for console logging
Troubleshooting August 2013 381
To Next Page
Loading...
