Avaya 2330/4134 - Booting from USB

Save bootrom image [0:AutoUpdate,1:NormalBTupd,
2:GoldenBTupd,3:NoUpd]: 0
If you select 0, 1, or 2, the router returns the following:
BOOT PARAMETERS HAVE BEEN SAVED.
14.
Reboot the Secure Router 2330/4134 to activate changes, or continue with your
configuration:
DO YOU WANT TO REBOOT: (Y/N) ? y
Booting from USB
You can configure the Secure Router 4134 to boot from a USB device.
Procedure steps
1.
Enter Configuration Mode:
configure terminal
2. Enter the command to configure boot parameters:
boot_params
The router will return the following message:
WARNING: Configuration changes not yet saved!
3.
When prompted, enter the name of the device from which you prefer the router
boots:
Boot dev [ftp,cf0,cf1,usb0]: usb0
4. Enter the boot file name (the router provides this information if you have previously
configured it):
Boot file name: SR4134.Z
5. Enter the name of the server you use (the router provides this information if you
have previously configured it):
Server name: sunserver
6. Enter the server IP address (the router provides this information if you have
previously configured it):
Server IP address: 10.10.11.12
7. Enter the router IP address (the router provides this information if you have
previously configured it):
My IP address: 10.10.13.14
Booting from USB
Troubleshooting August 2013 43