boot_params
The router will return the following message:
WARNING: Configuration changes not yet saved!
3.
When prompted, enter the name of the device from which you prefer the router
boots:
Boot dev [ftp,cf0,cf1,usb0]: ftp
4. Enter the boot file name (the router provides this information if you have previously
configured it):
Boot file name: SR4134.Z
OR
Boot file name: SR2330.Z
5. Enter the name of the server you use (the router provides this information if you
have previously configured it):
Server name: sunserver
6. Enter the server IP address (the router provides this information if you have
previously configured it):
Server IP address: 10.10.11.12
7. Enter the router IP address (the router provides this information if you have
previously configured it):
My IP address: 10.10.13.14
8. Enter the subnet mask (the router provides this information if you have previously
configured it):
My subnet mask: 255.255.255.0
9. Enter the gateway IP address (the router provides this information if you have
previously configured it):
Gateway IP address: 10.10.15.16
10. Enter your user name and password:
User name: kevx Password: kevx
11. Enter 0 to disable or 1 to enable the checksum feature:
Checksum enable [0:Disable,1:Enable]: 1
12. Enter 0 to disable or 1 to enable the display of the image header contents:
Show header enable [0:Disable,1:Enable]: 1
13. Enter the number (0, 1, or 2) that corresponds to the type of bootrom image update
that you prefer, or enter 3 if you prefer to not update the bootrom image:
Global troubleshooting tasks
42 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
