Unable to make FXO calls
If you are unable to make FXO calls, refer to the following sections for troubleshooting.
Verify that the port and dial peer are enabled
Make sure the port is not shut down using the show voice port summary command.
Figure 80: show voice port summary sample output
Make sure the dial peer is configured with the appropriate destination pattern and is not shut
down using the show dial-peer voice summary command
Figure 81: show dial-peer voice summary sample output
Verify DTMF dialing on the FXO link
Pulse dialing not supported in this release. Make sure to use DTMF dialing on the FXO link.
Verify that PLAR is configured
Connection
PLAR must be configured for FXO calls. Verify that it is configured using the show
voice port command.
Common problems and solutions
Troubleshooting August 2013 341
To Next Page
Loading...
