Figure 78: show dial-peer voice sample output
If the registration is not enabled, enter the following commands to enable the registration:
SR/configure# dial-peer voice pots 3 SR/configure/dial-peer-voice-
pots 3# authentication 3087771001 3087771001 SR/configure/dial-peer-
voice-pots 3# register e164
Note that the username and password specified in the authentication command must
match to the username and password configured on the registrar.
To verify the FXS registration status, use the show sip-ua register status
command.
Figure 79: show sip-ua register status sample output
Ping
If
the FXS phones are still not able to register, then verify whether the configured registrar can
be reached from the Secure Router 2330/4134 using the ping command.
Troubleshooting a SIP Media Gateway problem
340 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
