Figure 77: show sip-ua status sample output
If
the registrar is not configured, then configure it using the sip-ua registar command. For
example:
SR/configure# sip-ua registrar ipv4:47.100.107.46 expires 3600
Verify that registration is configured on the dial peer
If FXS phones are still not registered, then verify whether registration is enabled for the dial-
peer corresponding to the FXS port using the show dial-peer voice command. The
following figure shows the sample output for voice dial peer 3 that corresponds to the FXS
phone.
Common problems and solutions
Troubleshooting August 2013 339
To Next Page
Loading...
