The most common option to use is debug
voice cc routing, which acts as a type of trace
command, displaying the dial-peer matching. Verify the status of the dial peer first using show
dial-peer voice.
If debugging the routing does not identify the problem, then enable specific debugs. Enabling
all debugs at once provides too much output to provide meaningful information.
Syntax
[no] debug voice cc [sip | isdn | cas | pots | fsm | media | routing
| msm | all]
Table 77: Variable definitions
Variable Value
sip Enables SIP adaptor specific debugs.
isdn Enables ISDN adaptor specific debugs.
cas Enables CAS adaptor specific debugs.
pots Enables POTS adaptor specific debugs.
fsm Enables state machine specific debugs.
media Enables media specific debugs.
routing Enables call routing specific debugs
including dial peer matching.
msm Enables call control and media manager
specific debugs.
all Enables all the above debugs.
Example
SR# debug voice cc routing
debug voip dial-peer
Use this command to debug VoIP dial peers. Use the no form of this command to disable the
debug messages
Syntax
[no] debug voip dial-peer
Example
SR# debug voip dial-peer
Troubleshooting a SIP Media Gateway problem
308 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
