Avaya 2330/4134 - Specifying the Syslog Messages to Report

syslog
4. Specify
a host IP address and UDP port. If a port number is not specified, port 514
is used by default.
host_ipaddr <A.B.C.D> [port]
5. To add another Syslog server address, repeat step 4 until up to 5 Syslog servers
are added.
6. Enable Syslog.
enable
Table 86: Variable definitions
Variable Value
<A.B.C.D> Specifies the host IP address.
[port] Specifies (optionally) the UDP port. If not specified, port 514
is used by default.
Specifying the syslog messages to report
Use the commands in this section to specify the syslog messages that the Secure Router
2330/4134 reports.
Procedure steps
1.
To access configuration mode, enter:
configure terminal
2. To specify the syslog messages that the Secure Router 2330/4134 reports, enter:
system logging syslog module <module> <facility> <priority>
Table 87: Variable definitions
Variable Value
<facility> The source of the message. Valid values are
the following:
•
local0
• local1
• local2
• local3
• local4
• local5
• local6
Secure Router 2330/4134 system error messages
378 Troubleshooting August 2013
Comments? infodev@avaya.com