Environment management (Secure Router 2330 only)
This
section describes how to interpret the sensors. Sensor states are shown by the SYS and
FAN LEDs located on the rear panel of the chassis.
• Temperature Sensors - There is one temperature sensor on the board and the
temperature is sampled every two minutes.
• Fan - The status of the fan is checked every two minutes.
Verifying the hardware serial number
This procedure describes the steps necessary to verify the hardware serial number.
Procedure steps
To show the hardware serial, run the following command:
show system configuration
Verifying what software version is running
This procedure describes the steps necessary to show what software version the system is
running.
Procedure steps
To show the software version, run the following command:
show version
Booting from a network FTP server
You can configure the Secure Router 2330/4134 to boot from a network FTP server.
Procedure steps
1.
Enter Configuration Mode:
configure terminal
2. Enter the command to configure boot parameters:
Verifying the hardware serial number
Troubleshooting August 2013 41
To Next Page
Loading...
