Troubleshooting RIP
Use
the show and debug commands in this section for debugging issues related to RIP routing
behavior, including issues related to the RIP routes.
RIP debug options
You can enable the debug options selectively at the global level for different aspects of RIP
behavior. The following figure shows the debug rip options.
Figure 16: debug rip command options
The following figure shows the debug ipv6 rip options.
Figure 17: debug ipv6 rip command options
Use
the following commands for debugging issues related to route learning and packet flows:
• debug rip packet debug ipv6 rip packet
• debug rip events debug ipv6 rip events
For more information about the debug rip commands for IPv4, see
Debug command options
for RIP
on page 146. For more information about the debug ipv6 rip commands for IPv6,
see
Debug command options for RIPng for IPv6 on page 147
.
RIP show options
Use the RIP show commands to help you troubleshoot.
Troubleshooting unicast routing
134 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
