Avaya 2330/4134 - Module Leds for T1 or BRI Are off

Figure 57: show interface bundles sample output for PRI
The following figure shows a BRI port in a voice bundle that can be used as the clock
source.
Figure 58: show interface bundles sample output for BRI
Module LEDs for T1 or BRI are off
The
Secure Router 2330/4134 supports hot swap of identical external modules. If you boot up
and the LEDs on a module are off, the module may be in the process of being hot swapped.
To determine if the module is being hot swapped, enter the show chassis command. The
following figure shows a sample output when a module is being hot swapped.
Common problems and solutions
Troubleshooting August 2013 323