Note:
VLAN Classification is supported on Hybrid ports only.
Troubleshooting a configuration failure
VLAN Classification fails with VLAN doesn’t exist error
•
Make sure the VLAN is already created using the show bridge vlan command.
Assigning a VLAN Classification Rule to an interface fails
• Make sure the interface is in Hybrid mode using the show bridge port command.
Configuration fails with Rule Subnet overlaps with ruleId error
•
Verify the previously configured rule X is not in the same subnet. Use show running-
config command.
Troubleshooting a Data Link Layer problem
92 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
