Figure 3: debug ospf command options for IPv4 network
The following figure shows the debug ipv6 ospf options for an IPv6 network.
Figure 4: debug ipv6 ospf command options for IPv6 network
You
can also debug issues with adjacencies and packet flows on specific interfaces. To debug
issues at the interface, enable OSPF packet tracing on a specific interface. The following figure
shows IPv4 command options for OSPF packet tracing on an interface.
Figure 5: ip ospf debug packet command options for IPv4 network
The following figure shows IPv6 command options for OSPF packet tracing on an interface.
Troubleshooting unicast routing
128 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
