debug firewall ip-reassembly
debug firewall packet
debug firewall packet [<direction>|<srcip>|<destip>|
<protocol>|<numpkts>]
Table 69: Variable definition
Variable Value
<destip> Match the destination IP address. Default is any.
<direction> The packet direction. Possible choices are in, out, or
both. Default is both.
<numpkts> The number of packets to display. The default is 100.
<protocol> Match a protocol, by identifying number. Possible choices
are:
• 1
- ICMP protocol.
• 6 - TCP protocol.
• 17 - UDP protocol.
• 47 - GRE protocol.
• 50 - ESP protocol.
• 51 - AH protocol.
• any - Any protocol.
<srcip>
debug firewall all
debug firewall all
debug tacacs
Use this command to debug RSA secure-ID related messages.
Syntax
[no] debug tacacs
This command is used for both RADIUS and TACACS+ protocols.
Troubleshooting firewall
Troubleshooting August 2013 201
To Next Page
Loading...
