Table 3: Variable definition
Variable Value
<both> Both directions.
<in> Incoming packets.
<out> Outgoing packets.
Example
SR# debug pcap capture cap1
SR/debug/pcap/capture cap1# direction in
debug pcap capture snaplen
Use this command to configure the number of bytes to be captured.
Syntax
snaplen <0-65535>
Example
SR# debug pcap capture cap1
SR/debug/pcap/capture cap1# snaplen 1000
debug pcap capture count
Use this command to configure the number of packets to be captured.
Syntax
count <0 - 10000>
Example
SR# debug pcap capture cap1
SR/debug/pcap/capture cap1# count 5000
debug pcap capture filter
Use this command to configure the ACL applied.
Syntax
filter <aclname>
Global troubleshooting tasks
32 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
