Figure 96: show interface bundle sample output
You
can also display the voice port status by entering the show voice port command. The
following figure shows the operation state of the port as dormant.
Figure 97: show voice port sample output
To troubleshoot the issue, make sure that the T1 PRI cables are connected correctly. Also,
verify the D channel and link status from the PBX side. Also, see Unable to make calls on T1
PRI on page
325 for further troubleshooting instructions.
Troubleshooting a SIP Media Gateway problem
352 Troubleshooting August 2013
Comments? infodev@avaya.com
To Next Page
Loading...
