Becker MEXICO - Automatic Dialogue; Volume for Voice Output

176
Settings
Volume for voice output
You can set the volume for announce-
ments from your Mexico here.
X Select 9ROXPHRIYRLFHRXWSXW in the voice
mode settings.
X Select ,QGHSHQGHQWO\DGMXVWDEOH or 5HODWLYH
WRDXGLR
.
•
,QGHSHQGHQWO\DGMXVWDEOH
You can set the volume for announce-
ments independently of the volume set
for the audio source.
•
5HODWLYHWRDXGLR
The volume for announcements can be
set in a specific range based on the
volume set for the active audio source.
X For the 5HODWLYH WR DXGLR setting, select
9ROXPH.
X Turn the rotary control/push button
to select the required volume.
Automatic dialogue
You can specify which events should
trigger automatic voice dialogue. Auto-
matic dialogues are automatic queries
from the Mexico after particular events,
for example whether a voice entry is to
be created after a radio station has been
stored.
X Select $XWRPDWLF GLDORJXHV in the voice
mode settings.
X Next, select the required event.
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Note:
Only one of the two settings may be
active ( ) at the same time.
7007
Note:
If you have previously selected
5HODWLYH
WR DXGLR
, you can set the volume in the
range between -10 and +10. In this case,
a negative value means that announce-
ments will be made more quietly than
the selected volume for the audio
source.
7008
7009