Becker MEXICO - Disconnecting Devices

171
Settings
If the connection to the external device
is established successfully, another
signal tone can be heard and the
following message appears.
X Press the rotary control/push button
.
If the connection is terminated by the
external device after authentication, the
device list will be displayed.
If the connection is not terminated, the
following message will appear.
X Select between <HV, 1R and $OZD\V.
•
<HV
Connection to the external device is
allowed.
•
1R
Connection to the external device is
rejected.
•
$OZD\V
Connection to the external device is
allowed. The function described in
“Always allow connection” auf
Seite 166 will also be activated.
Further connection requests will be
accepted without a query.
If the connection to the external device
is established successfully, another
signal tone can be heard and the
following message appears.
X Press the rotary control/push button
.
A connection has now been established
to the external device.
Disconnecting devices
X Select the device to be disconnected
from the device list.
X Press the rotary control/push button
.
X Select <HV to disconnect or 1R not to
disconnect.
If
<HV is selected, the Mexico will
disconnect the required device.
7042
7039
7040
Note:
A connected device is identified by the
symbol.
7031
7043