Becker MEXICO - Voice Entries; Voice Output

177
Settings
Voice entries
You can use this function to read out and
delete all voice entries already stored for
the radio and address book functions.
X Select 9RLFH HQWULHV in the voice mode
settings.
Reading out:
X Select 5HDGRXWUDGLRor 5HDGRXWDGG
ERRN
.
The selected voice entries are read out.
Deleting:
X Select 'HOHWH UDGLR or 'HOHWH DGGUHVV
ERRN
.
X When the next prompt appears, select
<HV to delete the entry or 1R not to
delete.
Entries will be deleted or retained on the
basis of the selection.
Voice output
You can configure voice outputs for the
Mexico here.
X Select 9RLFH RXWSXW in the voice mode
settings.
X You may now select the 6LJQDOSULRUWR
YRLFHLQSXW
, &RQILUPYRLFHLQSXW and 'HWDLOHG
YRLFHRXWSXW
functions.
•
6LJQDOSULRUWRYRLFHLQSXW
Once the function has been activated,
in addition to being highlighted on the
Mexico, a beep tone sounds to indicate
that the unit is ready for a voice com-
mand.
•
&RQILUPYRLFHLQSXW
If the function is active, the voice
command is repeated by the Mexico
for confirmation. However, please
note that the voice command repeated
may not tally exactly with the voice
command you entered, but with the
main command. It may be the case, for
example, that you say “end” and the
Mexico repeats “cancel”. In voice
mode, these two commands have the
same meaning.
•
'HWDLOHGYRLFHRXWSXW
If the function is active, in some places
you will receive detailed instructions
(e.g. for entering a destination in voice
mode).
X Turn the rotary control/push button
to switch the required function on ( )
or off ( ).
Note:
The number of voice entries already
assigned appears on the right-hand side
of the display.
7010
7011