5.1.11 DRV-31 Quick Start
The inverter LCD boots up to the “Quick Start” menu on power up. The Quick Start menu contains
basic parameter settings for control and protection of a standard induction motor. The default
settings are used for a standard induction motor controlled with a linear (fixed) V/Hz. pattern with a
base frequency of 60 Hz.
• During programming, use escape (ESC) to exit the Quick Start menu.
• To access the Quick Start menu when already powered up, set DRV-31 (PopUp Q. Start) to “Yes” to return
to the Run Quick Start menu.
• The inverter will display the Quick Start menu on every power up. Parameter CNF-61 (Run Quick Start?) is
set to “Yes” by default. To disable the Quick Start menu at power up, set CNF-61 to “No”.
To Next Page
Loading...
