BENSHAW RSi H2 Series - Installing the Inverter

17
890053-00-02
Installing the Inverter
2 Installing the Inverter
This chapter describes the physical and electrical installation of the H2 series inverters, including
mounting and wiring of the product. Refer to the flowchart and basic configuration diagram provided
below to understand the procedures and installation instructions to be followed to install the product
correctly.
Installation Flowchart
The following flowchart lists the sequence to be followed during installation. The steps cover
equipment installation and testing of the product. More information on each step is referenced in the
steps.
Select the Installation Location (p.10)
Mounting the Inverter (p.20)
Parameter Configuration (p.72)
Testing (p.51)
Turn on the Inverter
Post-Installation Checks (p.49)
Power and Signal Wiring (p.27)
Wiring the Ground Connection (p.27)
Product Identification (p.1)