BENSHAW RSi H2 Series - PID Pgain2; PID Ref Change; Pre-Excite; Timer in

Parameter Descriptions
174
890053-00-02
5.6.16 PID PGain2
When operating in PI Control mode, a digital input can be set to ‘26 (PID Gain2)’. When activated, the
inverter switches from the PID PGain1 setting to the PID PGain2 setting. Refer to section 6 PID
Control Group (PID) for more details.
Group
Code
Name
LCD Display
Parameter Setting
Setting range
Unit
IN
65~71
Px terminal setting
options
Px Define
(Px: P1–P7)
26
PID Gain2
0-42
-
5.6.17 PID Ref Change
When operating in PI Control mode, a digital input can be set to ‘27 (PID Ref Change)’. When
activated, the inverter switches from the PID Ref 1 settings (PID-10 ~ PID-14) to the PID Ref 2
settings (PID-15 ~ PID-19). Refer to section 6 PID Control Group (PID) for more details.
Group
Code
Name
LCD Display
Parameter Setting
Setting range
Unit
IN
65~71
Px terminal setting
options
Px Define
(Px: P1–P7)
27
PID Ref
Change
0-42
-
5.6.18 Pre-Excite
A digital input can be set to ‘28 (Pre Excite)’ to stop and hold the motor prior to starting. Refer to
section 5.4.2.2 Start After DC Braking for more details.
Group
Code
Name
LCD Display
Parameter Setting
Setting range
Unit
IN
65~71
Px terminal setting
options
Px Define
(Px: P1–P7)
28
Pre Excite
0-42
-
5.6.19 Timer In
Add a timer function to the inverter. Set a digital input to activate the timer. Set outputs (Relay1 ~
5 or Q1) to respond to the input. Add On/Off delay times to the outputs.
Group
Code
Name
LCD Display
Parameter
Setting
Setting
Range
Unit
IN
65–71
Px terminal
configuration
Px Define
(Px: P1–P7)
29
Timer In
0~42
-
OUT
31
Multi-function relay1
Relay 1
22
Timer Out
0~43
-
33
Multi-function
output1
Q1 Define
55
Timer on delay
TimerOn delay
3.00
0.00–100
sec
56
Timer off delay
TimerOff delay
1.00
0.00–100
sec