BENSHAW RSi H2 Series - Quick Start Menu; Operation Time Monitor

LCD Display Modes
297
890053-00-02
Parameter Lock Setting Details
Code
Description
CNF-53
Key Lock Pw
Register a password to prohibit parameter modifications. Follow the
procedures below to register a password.
No
Procedures
1
Press the [PROG/ENT] button on CNF-53 parameter and the
saved password input window will be displayed. If password
registration is being made for the first time, enter 0. It is the
factory default.
2
If a saved password has been set, enter the saved password.
3
If the entered password matches the saved password, then a
new window to enter a new password will be displayed. (The
process will not move to next stage until the user enters a valid
password).
4
Register a new password.
5
After registration, Parameter CNF-53 will be displayed.
CNF-52
Key Lock Set
To enable parameter lock, enter the registered password. [Locked] sign
will be displayed on the screen to indicate that parameter lock is
enabled. Once enabled, pressing the [PROG/ENT] button on function
parameter CNF-52 will not allow the display edit mode to run. To enable
parameter modification, re-enter the password. The [Locked] sign will
disappear.
9.6.11 CNF-61 Quick Start Menu
The inverter will display the Quick Start menu on every power up. Parameter CNF-61 (Run Quick
Start?) is set to “Yes” by default. To disable the Quick Start menu at power up, set CNF-61 to “No”.
Refer to section 2.6 Run Quick Start on page 52 for more details.
Group
Code
Name
LCD Display
Parameter
Setting
Setting
Range
CNF
61
Quick Start menu setting
Run
QuickStart?
0
No
0 - 1
1
Yes
9.6.12 CNF-70 Operation Time Monitor
Monitors inverter and fan operation time.
Group
Code
Name
LCD Display
Parameter
Setting
Setting Range
Unit
CNF
70
Accumulated Inverter
Power On time
On-time
0/00/00 00:00
-
min
71
Accumulated inverter
operation time
Run-time
0/00/00 00:00
-
min
72
Initialize inverter
operation
accumulated time
Time Reset
0
No
0–1
-
If parameter view lock and parameter lock functions are enabled, no inverter operation
related function changes can be made. It is very important that you memorize the
password.