BENSHAW RSi H2 Series - Navigating Parameters Using Jump Codes

Performing Basic Operations
74
890053-00-02
3.2.6 Navigating Parameters using “Jump Codes”
The Jump Code feature allows moving directly to a specific parameter. The Jump Code is the first
code/number of each mode. The Jump Code feature is convenient when navigating for a specific
code/number in a function group that has many parameters.
The following example shows how to navigate directly to parameter DRV- 16 from the initial parameter
(DRV-00, Jump Code) in the Drive group.
MON K/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
PAR DRV STP 0.0Hz
00 Jump Code
CODE
1 ~ 99 Code
D:9 C:9
PAR DRV STP 0.0Hz
00 Jump Code
CODE
1 ~ 99 Code
D:9 C:9
PAR DRV STP 0.0Hz
16 Fwd Boost
2.0 %
17 Rev Boost
2.0 %
19 Start Freq
0.50 Hz
PAR DRV STP 0.0Hz
00 Jump Code
16 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
On power up, the LCD boots up in the monitor
(MON) mode.
•Press the MODE button once to move to the
parameter (PAR) mode.
Parameter (PAR) mode is displayed.
•The Drive (DRV) group of parameters is the
first parameter group to be displayed.
•At parameter DRV-00, Jump Code press the
PROG/ENT button.
•The parameter code "9" is highlighted.
•Using the up arrow button, scroll up to 16.
Press the PROG/ENT button.
The menu "Jumps" to parameter DRV-16. It can
be changed here using the PROG/ENT button.
Pressing the ESC button returns menu to DRV-
00.
N
N
N
N
9
N
16
N