BENSHAW RSi H2 Series - Selecting the Status Bar Display Item

Performing Basic Operations
76
890053-00-02
3.2.8 Selecting the Status Bar Display Item
At the top-right corner of the LCD display’s status bar is another frequency item. This item refers to the
frequency reference when the inverter stopped and the output frequency when the inverter is
operating. In HAND or OFF modes, this monitoring item always displays frequency reference. This
monitoring item can be changed to show the type of information that suits your needs. If changed, the
new item will show when in AUTO mode.
The following example shows how to change this monitoring item to Output Amps.
MON K/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
CNF STP 0.0Hz
00 Jump Code
42 CODE
01 Language Sel
English
02 LCD Contrast
CNF STP 0.0Hz
20 AnyTime Para
Frequency
21 Monitor Line-1
Frequency
22 Monitor Line-2
Output Current
CNF STP 0.0Hz
20 AnyTime Para
0 Frequency DC
1 Speed
2 Output Current
CNF STP 0.0Hz
20 AnyTime Para
0 Frequency DC
1 Speed
2 Output Current
CNF STP 0.0Hz
20 AnyTime Para
Output Current
21 Monitor Line-1
Frequency
22 Monitor Line-2
Output Current
MON K/K STP 0.0A
Frequency
0.00 Hz
0.0 A
0 kW
Press the MODE button to return to the monitor
(MON) mode.
On power up, the LCD boots up in the monitor
(MON) mode.
•In the status bar, at the top-right corner of the
display is the frequency reference/output
frequency (default). This displayed setting can
be changed with parameter CNF-20.
Press the MODE button to move to the
Configure (CNF) mode.
•Press the down arrow button to get to
parameter CNF-20, AnyTime Parameter.
•Press the PROG/ENT button. The default and
current (present) setting is Frequency DC.
Use the up/down arrow buttons.to see the
available display items for CNF-20.
At "2" Output Current, press the PROG/ENT
button to select Output Current as the displayed
item for CNF-20.
Display returns to the CNF parameter list.
N
N
N
N
N
N
N