BENSHAW RSi H2 Series - Trip Mode (TRP)

LCD Display Modes
288
890053-00-02
MC3 ---> Constant Torque
36
PRT
21
OL Trip Level
150
%
37
PRT
22
OL Trip Time
60.0
sec
38
PRT
31
No Motor Trip
1
Free-Run
39
PRT
32
No Motor Level
5
%
40
PRT
33
No Motor Time
3.0
sec
41
PRT
40
ETH Trip Sel
1
Free-Run
42
PRT
41
Motor Cooling
0
Self-cool
43
PRT
42
ETH 1 min
115
%
44
PRT
43
ETH Cont
100
%
9.5 Trip Mode (TRP)
If the inverter trips, it immediately displays the fault in the TRP Mode. The “OFF” button on the LCD
keypad will be flashing.
• Use the down arrow button to view the inverter data at the time of the fault.
• Faults can be reset by pressing the “OFF” button or from an external reset.
• Use the MODE button to move out of the TRP Mode to other display Modes.
• Trip mode (TRP) is not displayed unless the inverter has an existing fault or a fault history.
The inverter stores last 5 Faults. Last-1 is most recent.
Use Down Arrow button to view Fault data (TRP Codes 01 ~ 10). See table below.
Use Right Arrow button to move through the faults (1 -> 5).
Use Left Arrow button to move through the faults (5 -> 1).
Code
Name
LCD Display
Setting
Range
Initial Value
00
Trip type display
Trip Name(x)
-
-
01
Frequency reference at trip
Output Freq
-
-
02
Output current at trip
Output Current
-
-
03
Acceleration/ Deceleration
state at trip
Inverter State
-
-
04
DC section state
DCLink Voltage
-
-
05
NTC temperature
Temperature
-
-
06
Input terminal state
DI State
-
0000 0000
07
Output terminal state
DO State
-
00 0000
8
1
Trip time after Power on
Trip On Time
-
00/00/00 00: 00
9
1
Trip time after operation start
Trip Run Time
-
00/00/00 00: 00
10
Delete Fault History
Trip Delete?
0
No
Yes? Or No?
1
Yes
[1] Information is displayed in [YY/MM/DD Hr: Min (0/00/00 00:00)] format.
CNF-44
Clear Fault History
Erase All Trip
0
No
1
Yes
CNF-44 can be used to clear the Fault History.