BENSHAW RSi H2 Series - Moving Among LCD Display Modes

Performing Basic Operations
70
890053-00-02
3.2.3 Moving among LCD Display Modes
Pressing the MODE button will move through the various LCD display modes.
MON T/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
U&M USR STP 0.0Hz
00 Jump Code
1 CODE
01 Acc Time
20.0 sec
02 Cmd Source
Fx-Rx-1
TRP Last-1
00 Trip Name
Fuse Open
01 Output Freq
29.00 Hz
02 Output Current
74.6 A
CNF STP 0.0Hz
00 Jump Code
42 CODE
01 Language Sel
English
02 LCD Contrast
MON T/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
After the last mode (CNF), the menu returns to
the first mode. The Monitor (MON) mode is
displayed.
On power up, the LCD boots up in the monitor
(MON) mode.
•Press the MODE button once to move to the
parameter (PAR) mode.
Parameter (PAR) mode is displayed.
•Press the MODE button once again to move
to the User & Macro (U&M) mode.
•The User & Macro (U&M) mode is displayed
showing the USR group of parameters.
Note: If a User or Macro has not been
selected, the menu will skip the U&M Mode.
•Press the MODE button once again.
•The Trip (TRP) mode is displayed showing the
most recent fault.
Note: If the inverter does not have any fault
history, the menu will skip the TRP Mode.
•Press the MODE button once again.
•The Configure (CNF) mode is displayed. This
is the last mode.
•Press the MODE button once again.
U
U
U
U
U