BENSHAW RSi H2 Series - Viewing and Changing Parameter Values and Settings

Performing Basic Operations
72
890053-00-02
3.2.5 Viewing and Changing Parameter Values and Settings
3.2.5.1 Changing Parameters with Numerical Values
The following example shows how to view and change Accel Time (DRV-03).
MON K/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
PAR DRV STP 0.0Hz
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
03 Acc Time
20.0 sec
PAR DRV STP 0.0Hz
03 Acc Time
20.0 sec
0.0 ~ 600.0 sec
D:20.0 C:20.0
PAR DRV STP 0.0Hz
03 Acc Time
20.0 sec
0.0 ~ 600.0 sec
D:20.0 C:20.0
PAR DRV STP 0.0Hz
03 Acc Time
20.0 sec
0.0 ~ 600.0 sec
D:20.0 C:20.0
PAR DRV STP 0.0Hz
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
03 Acc Time
10.0 sec
Press the PROG/ENT button, the Accel Time
has been changed to 10.0 seconds.
On power up, the LCD boots up in the monitor
(MON) mode.
•Press the MODE button once to move to the
parameter (PAR) mode.
Parameter (PAR) mode is displayed.
•The Drive (DRV) group of parameters is the
first parameter group to be displayed.
•Press the down arrow button 3 times to get to
parameter DRV-03.
•With parameter DRV-03 highlighted, press the
PROG/ENT button.
•The cursor is highlighting the tenths digit.
Using left arrow button, move the cursor to the
tens digit with the "2" highlighted.
Press the down arrow button once, changing
the "2" to a "1".
N
N
N
N
0
N
2
N
1
N