BENSHAW RSi H2 Series - Page 85

Performing Basic Operations
73
890053-00-02
3.2.5.2 Changing Parameters with Lists
The following example shows how to view and change the command source (DRV-06).
MON K/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
PAR DRV STP 0.0Hz
04 Decel Time
30.0 sec
05 KPD H.O.A Lock
During Run
06 Cmd Source
Fx-Rx-1
PAR DRV STP 0.0Hz
06 Cmd Source
0 Keypad
2 Fx/Rx-2
PAR DRV STP 0.0Hz
06 Cmd Source
1 Fx/Rx-1
2 Fx/Rx-2
PAR DRV STP 0.0Hz
04 Decel Time
30.0 sec
05 KPD H.O.A Lock
During Run
06 Cmd Source
Keypad
•A list of settings for parameter DRV-06 appears
(0, 1, 2) showing the default and the current
setting (DC).
On power up, the LCD boots up in the monitor
(MON) mode.
•Press the MODE button once to move to the
parameter (PAR) mode.
Parameter (PAR) mode is displayed.
•The Drive (DRV) group of parameters is the
first parameter group to be displayed.
•Press the down arrow button 6 times to get to
parameter DRV-06.
•With parameter DRV-06 highlighted, press the
PROG/ENT button.
Using the up arrow button, move the cursor to
highlight the (0) Keypad selection.
Press the PROG/ENT button, the Command
Source parameter, DRV-06 has been changed
to Keypad.
N
N
N
N
1 Fx/Rx-1 DC
N
0 Keypad
N