4.2 Parameter Lists
Press the MODE button on the Keypad to move to the PAR Mode (upper left corner of LCD).
Press the right and left arrow buttons to move through the parameter groups.
The following tables list the parameter groups and all the parameters within each group. Set the
parameters according to your operating requirements.
Parameters shaded in gray will be displayed when a related parameter has been selected.
The column labeled
“Property”
shows whether the parameter can be changed while the inverter
is running according to the following:
O:
Write enabled during run,
Δ:
Write Disabled during run
, X
: Read/View only.
Additionally, an
“I”
or a
“P”
(or both) in the Property column relate to parameter DRV-09,
Control Mode settings for Sensorless Vector Control and indicate which Sensorless Control
Mode they apply to according to the following:
I:
Induction Motor,
P:
Permanent Magnet Motor.
4.2.1 Drive Group (DRV)