BENSHAW RSi H2 Series - Parameter Lists and Quick Reference; Quick Reference Table

Parameter Lists
81
890053-00-02
4 Parameter Lists and Quick Reference
4.1 Quick Reference Table
Refer to the below table for a list of functions and a link to the parameter description pages.
Groups
Description
Ref.
DRV Group
Move to DRV Group
p.101
MOT Group
Move to MOT Group
p.122
BAS Group
Move to BAS Group
p.127
ADV Group
Move to ADV Group
p.138
CON Group
Move to CON Group
p.154
IN Group
Move to IN Group
p.161
OUT Group
Move to OUT Group
p.179
COM Group
Move to COM Group
p.299
PID Group
Move to PID Group
p.220
AP1 Group
Move to AP1 Group
p.233
AP2 Group
Move to AP2 Group
p.256
AP3 Group
Move to AP3 Group
p.269
PRT Group
Move to PRT Group
p.191
CNF Mode
Move to CNF Mode
p.279
Quick Start menu
Quick Set Up of basic parameters.
p.52
Basic Tasks
Description
Ref.
HAND / OFF / AUTO buttons
Select the operation mode.
p.62
Acc/Dec times
Set acceleration and deceleration times.
p.102
Start Stop control sources
Set Start Stop sources.
p.104
Frequency Reference sources
(Keypad, Analog Inputs)
Configure Frequency Reference sources.
p.107
Digital Inputs
Configure Digital Input Terminals
p.163
Set Digital Input to NC
Configure a Normally Closed Digital input
p.177
Analog Outputs
Configure Analog Output Terminals
p.179
Relay Outputs
Configure Digital Output Relays
p.183
Set Relay Output to NC
Configure a Normally Closed Relay Output
p.189
Motor Data
Set Motor Parameters
p.122
PID Control
Set PID Control settings
p.220
Control Mode (V/Hz., Slip Comp)
Set Motor control settings
p.117
Set Volts/Hz. pattern
Configure Linear, Squared, User V/Hz. Curve
p.131
Control Mode (SVC)
Set Sensorless Vector Control settings
p.239
Auto Tuning
Run Motor Auto Tuning
p.124
Start Modes
Set Accel or DC Injection Starting
p.140
Dual Ramps
Set a Switch Frequency for Dual Ramps
p.135
Stop Modes
Set Coast, Decel, Braking Stop Methods
p.141
Jogging
Set Jog speed and jog accel/decel times.
p.165
Torque Boost
Set boost levels. Set manual or automatic boost.
p.118
Frequency Limits
Set Frequency Limits on inverter output.
p.147
Speed Search
Start into a spinning load.
p.156
Regen Avoidance
Handle energy in operating in Regen Mode.
p.153