BENSHAW RSi H2 Series - Fault and Warning List

LCD Display Modes
289
890053-00-02
9.5.1 Fault and Warning List
The following is a list of faults and warnings that can occur while using the H2 inverter. For details,
refer to 11, Troubleshooting on page 341.
Category
LCD Display
Details
Major fault
Latch type
Over Current1
Over current trip
Over Voltage
Over voltage trip
External Trip
External signal, trip at digital input
NTC Open
Temperature sensor fault
Over Current2
ARM short current fault
Option Trip-x*
Option fault*
Over Heat
Over heat fault
Out Phase Open
Output open-phase fault
In Phase Open
Input open-phase fault
Ground Trip
Ground fault
Fan Trip
Fan fault
E-Thermal
Motor overheat fault
TB Trip
Terminal Board Connection fault
IO Board Trip
IO Board connection fault
No Motor Trip
No motor fault
Low Voltage2
Low voltage fault during operation
ParaWrite Trip
Write parameter fault
Pipe Broken
Pipe Break fault
Damper Err
Damper Err trip
Over Load
Motor overload fault
Under Load
Motor under load fault
PC Repeat Err
Pump clean repeat fault
Level Detect
Level detect trip
Inverter OLT
Inverter overheating trip
Thermal Trip
Motor overheating trip
Lost Keypad
Lost keypad trip
Broken Belt
Broken belt trip
Pipe Broken
Pipe Broken trip
Ext Brake
External brake fault
Fuse Open
Fuse Open trip (315~500kW)
InFAN Trip
Inner Fan trip (110~500kW)
Level type
Low Voltage
Low voltage fault
BX
Emergency stop fault
Lost Command
Command loss trip
Lost Keypad
Lost keypad trip
Hardware
damage (Fatal)
EEP Err
External memory error
ADC Off Set
Analog input error
Watch Dog-1
CPU Watch Dog fault
Watch Dog-2