BENSHAW RSi H2 Series - Switching Parameter Groups in Parameter Mode (PAR)

Performing Basic Operations
71
890053-00-02
3.2.4 Switching Parameter Groups in Parameter Mode (PAR)
After entering Parameter mode from Monitor mode, press the Right arrow button to move to the next
parameter group. Press the Left arrow button to go back to the previous group.
MON K/K STP 0.0Hz
Frequency
0.00 Hz
0.0 A
0 V
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
PAR MOT STP 0.0Hz
00 Jump Code
10 CODE
01 Motor Capacity
7.5 HP
02 Base Freq
60.00 Hz
PAR BAS STP 0.0Hz
00 Jump Code
20 CODE
01 Cmd 2nd Src
Fx/Rx-1
02 Freq 2nd Src
Keypad-1
ADV -> CON -> IN -> OUT -> COM -> PID -> AP1 -> AP2 -> AP3 -> PRT
PAR PRT STP 0.0Hz
00 Jump Code
40 CODE
01 Backspin Time
0.0 sec
04 Load Duty
Normal Duty
PAR DRV STP 0.0Hz
00 Jump Code
9 CODE
01 Cmd Frequency
0.00 Hz
02 Keypad Run Dir
Forward
After the last group (PRT), the menu returns to
the first group, the Drive (DRV) group of
parameters is displayed.
Parameter (PAR) mode is displayed.
•The Drive (DRV) group of parameters is the
first parameter group to be displayed.
•Press the right arrow button.
On power up, the LCD boots up in the monitor
(MON) mode.
•Press the MODE button once to move to the
parameter (PAR) mode.
•The Motor (MOT) group of parameters is the
second parameter group to be displayed.
•Press the right arrow button.
•The Basic (BAS) group of parameters is the
third parameter group to be displayed.
•Press the right arrow button 10 times to
move through the remaining parameter
groups.
•The Protection (PRT) group of parameters is
the last parameter group to be displayed.
•Press the right arrow button.
N
N
N
N
N
N