BENSHAW RSi H2 Series - PID Step Ref L, PID Step Ref M, PID Step Ref H; Digital Input Terminal Control

Parameter Descriptions
177
890053-00-02
5.6.28 PID Step Ref L, PID Step Ref M, PID Step Ref H
Three digital inputs can provide up to 7 different Step References (setpoints). Refer to section 6 PID
Control Group (PID) on page 220 for more details.
Group
Code
Name
LCD Display
Parameter Setting
Setting range
Unit
IN
65~71
Px terminal setting
options
Px Define
(Px: P1–P7)
40
PID Step Ref L
0-42
-
41
PID Step Ref M
42
PID Step Ref H
5.6.29 Digital Input Terminal Control
An On Delay and/or Off Delay time can be applied to all digital input terminals. The default setting
for all terminals is enabled "1" (On) which applies one On Delay (IN-85) and one Off Delay (IN-86)
filter time to all terminals. To disable the delay time for a specific terminal, set the bit for the
terminal to "0" (Off). Note: Longer time settings will delay the response of the input.
Additionally, the digital inputs can be configured independently as a normally open input or a
normally closed input (IN-87). The status of the inputs can be viewed at IN-90.
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
IN
83
Enable On Delay
DI On DelayEn
0 0000 0000 -
1 1111 1111
-
84
Enable Off Delay
DI Off DelayEn
0 0000 0000 -
1 1111 1111
-
85
Multi-function input
terminal On filter
DI On Delay
10
0–10000
msec
86
Multi-function input
terminal Off filter
DI Off Delay
3
0–10000
msec
87
Multi-function input
terminal selection
DI NC/NO Sel
0 0000 0000 -
1 1111 1111
-
90
Multi-function input
terminal status
DI Status
0 0000 0000 -
1 1111 1111
-
P8 and P9 terminals are on the Extended I/O PCB.