BENSHAW RSi H2 Series - Parameter Initialization

Performing Basic Operations
79
890053-00-02
3.4 Parameter Initialization
The following example demonstrates how to reset all the parameter settings back to the factory default
settings. Parameter initialization may be performed on individual parameter groups as well.
NOTE: The MOT Group is not initialized.
CNF STP 0.0Hz
00 Jump Code
42 CODE
01 Language Sel
English
02 LCD Contrast
CNF STP 0.0Hz
40 Parameter Init
------------- No ------------
41 Changed Para
View All
42 Multi-Key Sel
None
CNF STP 0.0Hz
40 Parameter Init
0 ------------ No ---------- DC
1 All Grp
2 DRV Grp
CNF STP 0.0Hz
40 Parameter Init
------------- No ------------
41 Changed Para
View All
42 Multi-Key Sel
None
Press the MODE button to move to the
Configure (CNF) mode.
•Press the down arrow button to get to
parammeter CNF-40.
Press the PROG/ENT button at CNF-40.
•Displays the list of options.
Press the down arrow button to highlight "1 All
Grp".
Press the PROG/ENT button to initialize All
Groups.
The display will return to parameter CNF-40
after parameter initialization.
N
N
N
N