9 LCD Display Modes
9.1 LCD Display Mode Selection
The keypad enables movement among display modes and within each mode. It enables users to
select, configure and view parameters and functions in each mode.
The following figure illustrates how to move through the display modes when you press the MODE
button on the keypad. Continue to press the MODE button until you get to the desired mode.
User & Macro mode (U&M) is only displayed when a User Group has been created or a Macro group
has been selected. Also, the Trip mode (TRP) is not displayed unless the inverter has an existing
fault or a fault history.
Monitor Mode (MON) - Ref section 9.2
Parameter Mode (PAR) - Ref section 9.3
User & Macro Mode (U&M) - Ref section 9.4
Trip Mode (TRP) - Ref section 9.5
Configure Mode (CNF) - Ref section 9.6
To Next Page
Loading...
