BENSHAW RSi H2 Series - Page 255

Sensorless Vector Control
243
890053-00-02
Code
Description
ACR SL I Gain
CON-50
V Con HR
CON-51
V Con Ki
Voltage Controller - Adjusts the limit and I Gain of the sensorless voltage
controller. Used for maximum voltage output at 60 Hz. For adjustments of
the voltage controller, refer to Sensorless Vector Control Operation
Guide.
CON-52
Torque Out LPF
Sets the time constant for torque command by setting the torque
controller output filter.
CON-53
Torque Lmt Src
Select a source for torque limit setting among keypad, analog inputs
(V1, V2 or I2), communications or pulsed input. Setting torque limits
adjusts the torque amount by limiting the speed controller output.
Setting
Function
0
KeyPad-1
Sets the torque limit with the LCD display.
1
KeyPad-2
2
V1
Sets the torque limit with the analog input terminal
of the terminal block.
4
V2
5
I2
6
Int 485
Sets the torque limit with the communication
terminal of the terminal block.
8
FieldBus
Sets the torque limit with the FieldBus
communication option.
9
UserSeqLink
This enters the torque reference by linking the
common area with the user sequence output.
12
Pulse
Sets the torque limit with the pulse input of the
terminal block.
When CON-53 is set to “0 (Keypad-1)” or “1 (Keypad-2)”, set the
torque limits with CON-54 ~ CON-57. The torque limit can be set up to
200% of the motor rated torque. Set the retrograde (motoring) and
regenerative limits for forward and reverse operation.
CON-54
FWD +Trq Lmt
Sets the torque limit for forward retrograde (motoring) operation.
CON-55
FWD –Trq Lmt
Sets the torque limit for forward regenerative operation.
CON-56
REV +Trq Lmt
Sets the torque limit for reverse retrograde (motoring) operation.
CON-57
REV –Trq Lmt
Sets the torque limit for reverse regenerative operation.
CON-91
CON-92
CON-93
SL Volt Comp1-3
Sensorless Motoring Dead Time Compensation Ratio
Sensorless Generating Dead Time Compensation Ratio
Adjust output voltage compensation values for sensorless vector
control. For output voltage compensation, refer to Sensorless Vector
Control Operation Guide.
CON-94
SL FW Freq
Field Weakening Start Frequency
CON-95
SL Fc Freq
Gain Switching Frequency
CON-97
SL Slip Comp1
Sensorless Motoring Slip Compensation Ratio
CON-98
SL Slip Comp2
Sensorless Generating Slip Compensation Ratio
Adjust the controller gain according to the load’s characteristics. However, the motor can
overheat or the system may become unstable depending on the controller gain settings.