BENSHAW RSi H2 Series - Page 294

LCD Display Modes
282
890053-00-02
Code
Description
󰪽 Parameter number to be used in the user group. Pressing
the [PROG/ENT] button on the parameter number (40
Parameter) will register DRV-01 as parameter 40 in the user
group.
󰪾 Existing parameter registered as the user group parameter
40
󰪿 Setting range of the user group parameter. Entering 0
cancels the settings.
3
Set a parameter number (󰪽) to use to register the parameter
in the user group. Select parameter number and press
[PROG/ENT]button.
4
Changing the value in 󰪽 will also change the value in 󰪾. If
no parameter is registered, ‘Empty Code’ will be displayed.
Entering 0 cancels the settings.
5
The registered parameters are listed in the user group in U&M
mode. You can register one parameter multiple times if
necessary. For example, a parameter can be registered as
parameter 2, parameter 11, and more in the user group.
Follow the procedures below to delete individual parameters from the
user group.
No.
Settings
1
Set CNF- 42 to ‘1’ (UserGrp SelKey). A icon will be
displayed at the top of the LCD display.
2
In the USR group in U&M mode, move the cursor to the
parameter that is to be deleted.
3
Press the [MULTI]button.
4
Move to YES on the deletion confirmation screen, and press
the [PROG/ENT]button.
5
Deletion completed.
CNF-45
UserGrp AllDel
Set to 1(Yes) to delete all registered parameters in the user group.